4 - Europe Gold pool assembly


1 - Open out the pool and spread it carefully on the selected area removing as many creases as possible. The holes for the Skimmer will be in the right hand corner.

Tenere presente durante il posizionamento che i fori per lo Skimmer si trovano sempre nell'angolo destro di una delle due testate.


2 - Assemble the wall fittings following the filtration system directions (Boa system pg.14/15, Laghetto/Jacuzzi system pg. 16/17).
(vedi Impianto Boa, Impianto Laghetto/Jacuzzi®)



3 - Insert the poles into the upper pockets through the special opening (first the two long sides and then the two short ones) matching the holes of the border poles with the holes of the white PVC pocket. To make it easier to slide the poles into the pocket, we recommend sprinkling them with talcum powder.

     

4 - Assemble all V poles and place them next to the foot straps. Each V pole is made up of two halves which must be inserted each other (1 x male fitting and 1 x female fitting) 4 spacers and 2 inox rings connected as shown in the illustration.


5 - Push all the V poles into the holes of the corresponding border poles

  


6 - With one person standing inside the pool, raise a corner, lifting the V poles until the inox rings are close enough to the foot straps to allow second person to insert the pins through the foot straps. Repeat the operation in the other corners and then on the sides.

7 - Once all the pins are inserted (before coming out of the pool), connect the Skimmer for the filtration system.(vedi pagina specifica).


8 - Smooth out creases in the bottom by gently pulling the webbing straps of the pool supports (never pull the poles!!).

9 - Connect the pool / filtration system connection hoses.

10 - If it's necessary put boards under the feet.


11 - Check that all V poles are completely inserted into the border.

12 - Start filling up the pool and when there are 3-5 cm. of water covering the bottom you will be able to gently pull out any remaining creases, by pulling on the webbing straps of the pool supports.

13 - Complete the filling of the pool until the water has reached the middle of the inside white border.

 

 

WARNING !

When the pool is full is not possible to pull the webbing straps of the supports to remove any creases in the bottom or move the legs if they are in the wrong position; the strain would damage the straps (remember always the huge weight of the water). In this case you must always empty out the pool first to make any adjustments.