Baby pool assembly


1 - Open the pool skin and spread it on the selected area.
	2 - Assemble the upper border tube. The long sides are made up of: 1 x A tube at the beginning and 1 x C at the end, with 1 or 2 x B tubes in the middle. The short sides are made up of 1 x A tube and 1 x C tube.
	3 - Stretch the pool out to allow the frame tubes to be inserted. Slip the tubes into the pocket edge of the skin through the special openings in the corners. First those in the long side and then those in the short side.
	4 - The holes in the tubes must line up with the holes in the pocket edge.
	5 - Slip all the V leg supports into the foot straps.
	6 - Starting at the four corners, push the V legs into the holes of the corresponding border tubes (it is easier to do this, if one person is in the pool lifting the edges whilst the other pushes in the legs from the outside).
	7 - If the ground is not paved, place under each leg support a wooden board 25 x 20 x 2 cm. The grain of the wood must be placed at the right angles to the support.
	8 - If the ground is paved, place under each leg a piece of anti abrasive material (ie. cloth, plastic sheet, etc…) 25 x 20 cm.
	9 - When the pool is filling with water the sides will gradually lift as shown in the picture.