3 - Azur pool assembly


    


1 - Open out the pool and spread it carefully on the selected area removing as many creases as possible. The holes for the Skimmer will be in the right hand corner.

2 - Assemble the wall fittings following the filtration system directions (Boa system pg.14, Laghetto/Jacuzzi system pg. 16).
(vedi Impianto Boa, Impianto Laghetto/Jacuzzi®).

3 - Assemble the poles of the upper pockets, starting with 1 pole A, as many poles B as necessary to make up the length (following the plan) and ending with 1 pole C.



4 - Insert the poles into the upper pocket through the special opening (first the two long sides and then the two short ones) matching the holes of the border poles with the holes of the white PVC pocket. To make it easier to slide the poles into the pocket, we recommend sprinkling them with talcum powder.

  


5 - Slip all the V poles into the webbing pool straps.

6 - Starting from the four corners, push the V poles into the holes of the correspondent border poles (it is easier to do this if one person is inside the pool lifting the edges while another pushes the poles into the holes from the outside).

7 - Slide the support reinforcement onto the feet.

8 - Attach the Skimmer for the filtration system (see pg.15)(vedi pagina specifica)
9 - Smooth out the bottom to remove any creases by gently pulling the webbing straps of the pool supports (never pull the poles!!).


10 - Join up the pool / filtration system connection hoses.
11 - If it's necessary put the boards under the feet.

12 - Check that all V poles are completely inserted into the border.


13 - Start filling up the pool and when there are 3-5 cm. of water covering the bottom you will be able to gently pull out any remaining creases, by pulling on the webbing straps of the pool supports.

14 - Complete the filling of the pool until the water has reached the middle of the inside white border.

 

 

WARNING !

When the pool is full is not possible to pull the webbing straps of the supports to remove any creases in the bottom or move the legs if they are in the wrong position; the strain would damage the straps (remember always the huge weight of the water). In this case you must always empty out the pool first to make any adjustments.